1. Be cautious when using cleaning agents
When using an ultrasonic cleaning machine, it is necessary to operate in the order required by the specifications, especially if the cleaning agent cannot be poured in after the machine is turned on. This is a violation that can cause serious consequences and even damage the machine. Therefore, it is necessary to first put in the liquid and then turn on the switch. At the same time, the manufacturer of the ultrasonic cleaning machine reminds that the composition of the cleaning agent should also be taken into account. If it contains flammable liquids, the operation must be completed in a short period of time, and there must be supervision throughout the entire process. It is not allowed to leave the site.

2. Pay attention to special treatment when using corrosive or volatile cleaning fluids

Normally, the use of hazardous cleaning fluids is not recommended, but if the situation is special and it is emphasized that ultrasonic cleaning machine manufacturers must use liquids containing corrosiveness or volatility, indirect methods should be adopted for proper treatment. The specific operation method introduced by the ultrasonic cleaning machine manufacturer is to first add water to the cleaning tank, then use a separate container to hold the cleaning solution and put in the items that need to be cleaned, and then immerse them in the water of the cleaning tank. Cleaning in this way will also achieve the same effect and ensure safety issues.

3. Pay attention to controlling the relevant factors of cleaning

It is recommended not to place the items that need to be cleaned at the bottom. Instead, a specialized cleaning bracket should be used to place them overhead in the middle position, so that they can be evenly stressed during eating and achieve good cleaning results. At the same time, high-end ultrasonic cleaning machine manufacturers remind us to pay attention to the control of the energy of the cleaning solution placed, and not to put too little, otherwise the instrument may be damaged or malfunction may occur.

4. It is recommended to use stainless steel baskets instead of plastic ones for cleaning baskets to prevent the generation of static electricity.

5. The time for each process during cleaning is set at 3-5 minutes. If the surface area of the cleaning material is large or the structure is complex, the cleaning time can be adjusted appropriately according to the situation. If the cleaning material is prone to overlap and adhesion, shake the workpiece when placing and removing the cleaning material from the tank, allowing the cleaning agent to fully contact the workpiece and improve the cleaning effect.

6. When draining, the cleaning basket should be tilted at a 45 degree angle and placed on the edge of the cleaning tank to drain. When lifting, the leaking ultrasonic cleaning agent should not be dropped into the nearby tank.

7. The tank liquid should not be too full to avoid mixing between the two ultrasonic cleaning agents and the phenomenon of mucus at the bottom of the cleaning basket when draining.

8. Each slot of the ultrasonic cleaning machine should be an independent operating process. It is strictly prohibited to use multiple slots of cleaning machines in series or artificially reduce the operating process and time. The efficiency of using ultrasonic cleaning agents should be maximized to reduce waste.

9. The working environment for ultrasonic cleaning should maintain air circulation, and it is strictly prohibited to introduce open flames or substances that are prone to open flames at the work site. The temperature of the liquid in the cleaning tank should be controlled below 50 degrees to reduce the volatilization of ultrasonic cleaning agents.